FT-2000 Menu and Memory Saver                        HB9ZS

Main Window after program start



In the "Transmit Buffer" Window you may enter any CAT Command followed by the ";" and "Enter".
The Transceiver will acct according to the command you sent. 



First of all set the communication with your FT-2000

Click on to the "COM-Port" and then "Comport Settings" or select the 6th Icon below the menu.

              



The "COM-Port Settings" window will be opened

 - Select the Serial Port you are using for the communication with the FT-2000
 - Select the speed equal to the settings in menu 27 of the FT-2000.
 - Set RTS in menu 29 to "OFF". If RST is "ON", the Communication will be blocked.
 - Click "OK". Window will close

Open the Com Port by clicking on the 5th Icon. The red indication in the menu bar will switch to green .

Save your menu settings of the FT-2000 on your Computer

 - Select "File" and then "Save Menu of FT-2000" or click to the first Icon.



           


 - the program will read the menu settings of your FT-2000.




 - At the end the "Save FT-2000 Menu" will be opened
 - Type in a name for your file name.
 - Click "Speichern" or "Store" 
 - All Menu Settings are now stored.








Restore your menu settings from the computer file in to your FT-2000

- Click on to the second Icon 





 - The "Restore FT-2000 Menu will be opened
 - Select a file
 - Click on "Open" 






 - The restore procedure will be started and at the end in the "Transmit Buffer" window 
   the "Terminated" information is shown. 









Save your Memory Setting of the FT-2000 to your Computer


- Select "File" and then "Save Memory of FT-2000" or click to the 3rd Icon.




 - the program will read the Memory content of your FT-2000






 - At the end the "Save FT-2000 Memory" will be opened
 - Type in a name for your file name.
 - Click "Speichern" or "Store" 
 - All Memory Settings are now stored.









Restore Memory content to the FT-2000


- Click on to the 4rd Icon 

 - The "Restore Memory to FT-2000 Menu will be opened
 - Select a file
 - Click on "Open" 







 - The restore procedure will be started and at the end in the "Transmit Buffer" window 
   the "Terminated" information is shown.